/
Creating an arc tangential to two lines
GiD - The personal pre and post processor
Creating an arc tangential to two lines
- Enrique Escolano
Owned by Enrique Escolano
Last updated: Jun 18, 2021
- Choose Geometry->Create->Arc->Fillet curves.
- Enter a radius of 1.35 in the command line.
- Now select the two line segments shown in next figure. Then press ESC to indicate that the process of creating the arcs is finished.
, multiple selections available,
Related content
Creation and meshing of a line
Creation and meshing of a line
More like this
Line thickness
Line thickness
More like this
Stream lines
Stream lines
More like this
Stream lines
Stream lines
More like this
Assignment following chordal error criterion
Assignment following chordal error criterion
More like this
Creation and meshing of a surface
Creation and meshing of a surface
More like this
COPYRIGHT © 2022 · GID · CIMNE